Product bundle

Complete 10-lane scoring system with mobile firing line for 200-600yd

If you desire highest quality scoring at 200-600yds shooting distances, this package should appeal. Rugged outdoor equipment with wireless and mobile monitors. Targets applied 4-sensor closed chamber technology making any weather condition immaterial. Never experience problems with acoustic interference from neighboring targets. This system handles any situation and environment, always maintaining world leading accuracy!
Price from $Contact your local dealer for price
Long range electronic target and wireless monitor solution

Package specifications

200yds-600yds electronic target - kongsberg

10 electronic targets (Model H4H 182cm/6ft wide), including following consumables:

  • 200yd SR templates
  • 300yd SR templates.
  • 600yd MR templates.
  • Other templates can be supplied on request (like F-class).
  • X-rubber patch to seal the sound chamber
  • Temperature shields
kongsberg wireless monitor with electronic target software

10 rugged 10.1’’ outdoor monitor tablets

  • Touch screen operation
  • Wireless
  • At least 10 hours operating time. Battery hot swap option. Spare batteries can be supplied on request. Power saving mode available.
  • Battery charger / mains power supply
  • Monitor stand
Orange Pelicase for electronic targets and system battery

Battery pack for firing line equipment

  • At least a full day of operation provided the battery is fully charged.
  • Battery charger, 3-step
  • Fitted in PeliCase
Gray Pelicase for firing line equipment

Firing line PeliCase

  • For interconnection of antennas and battery pack.
Range communication equipment

Radio antennas

  • Link between target- and firing line
  • Access point for shooters monitors
  • Two antenna stands
Electronic targets power and communication cabinet with power light

Power supply cabinet at target line.

  • 90-240VAC input voltage
  • 240VA output
  • Mains surge protection
roll of cable

All necessary cables.

  • Target cables
  • Antenna cables

Add-ons and options

Our systems can be tailor made to fit any requirements. If you have specific needs that are not included in our package bundles, please contact us for a quote made especially for your range. 

  • The target is tested and proved with following calibers: .22LR, .223, 6.5x55 and .308. Similar calibers should work perfectly, but .22LR should be regarded as the lowest bullet energy possible and should only be used at 100m/yds.
  • Enclosed cables require targets to be mounted with a maximum center-center distance of 2m/yds. Other cable lengths can be provided at an additional cost.
  • Power supply at target line must be mounted with a maximum distance of 5m/yds from first target in line and must be protected against rain. Other cable lengths can be provided at an additional cost. This power supply require 120W (110-240VAC).
  • Power supply at firing line require maximum 240W (110-240VAC). Enclosed cables require it to be mounted with a maximum distance of 15m/yds from any monitor (preferably at same place as the SDU-3 and the control room computer).
  • The lower part (50cm / 20inches) of the targets should be protected against stray bullets by a berm or knee wall. This will protect target electronics and lower sensors. Upper sensors (3 pcs) are exposed to stray bullets (to gain optimal scoring accuracy of the target), but the target is made easy to repair. Similar targets with no upper sensors may be provided on request.
  • The targets require maintenance. Maintenance frequency may wary by shooter skills, shooting distances and calibers in use. An estimate would be every 500 shot at 100m/yds, 1600 shots at 200m/yds or 3000 shots at 300m/yds.
  • This package does not include computer(s) or screens to run control room software, spectator viewing or local network (LAN) to interconnect potential computers.
  • Shooting range infrastructure like target base, target stands, knee walls, bullet catchers, roofed firing line etc.
  • Installation. System can be installed by customer in a few hours.
  • All of the above can be provided with an additional cost. Contact our sales team or fill out the form at the bottom of this page for a quote specifically tailor made for your requirements

  • Shipping is not included. To get an estimate, contact our sales department
  • Enclosed cables require targets to be mounted with a maximum center-center distance of 2m/yds. Other cable lengths can be provided at an additional cost.
  • Power supply at target line must be mounted with a maximum distance of 5m/yds from first target in line and must be protected against rain. Other cable lengths can be provided at an additional cost. This power supply require 120W (110-240VAC).
  • Power supply at firing line require maximum 240W (110-240VAC). Enclosed cables require it to be mounted with a maximum distance of 15m/yds from any monitor (preferably at same place as the SDU-3 and the control room computer).
  • The lower part (50cm / 20inches) of the targets should be protected against stray bullets by a berm or knee wall. This will protect target electronics and lower sensors. Upper sensors (3 pcs) are exposed to stray bullets (to gain optimal scoring accuracy of the target), but the target is made easy to repair. Similar targets with no upper sensors may be provided on request.
  • The targets require maintenance. Maintenance frequency may wary by shooter skills, shooting distances and calibers in use. An estimate would be every 500 shot at 100m/yds, 1600 shots at 200m/yds or 3000 shots at 300m/yds.

Do you need help switching to a ELECTRONIC target system?

Fill out this form, or contact your local Kongsberg Target Systems agent here.

Kongsberg Target Systems Heistadmoen Industripark
N-3608 Heistadmoen
KONGSBERG
Norway

Telephone: +47 32 76 30 00
Mail: sales@kongsberg-ts.no

Contact us for more information

© 2021 Kongsberg Target Systems
Design and development by Godt Sagt